Iron On Tactical USA Flag Patch ACU - 3-1/2" x 2-1/8" Left Shoulder
3-1/2" x 2-1/8"Â Tactical ACU American Flag withÂ Heat Seal Backing (Does Not Have A Velcro Backing) that isÂ ready to be sewn or fused with an iron or heat pressÂ (375 degrees with maximum pressure for about 25 seconds).Â Each embroidered American flag patch comes with an overlocked merrowed border and a heat seal backing. Patches are ready to be ironed or sewed on. Our colorfast threads are designed to withstand the harshest of washing processes
- Wash fabric first. Fabric softener should not be used.
- Set iron to cotton setting. Do not use steam, and remove water from iron.
- Lay your garment out on a hard, heat tolerant surface. A padded ironing board is not hard enough. Try placing a cutting board above padding.
- Place heatseal side of patch onto fabric in desired placement area. Iron design for approximately 30-60 seconds, applying pressure. Do not move iron side to side as this may cause design to shift. Heavier fabrics may require more time, and lighter fabrics may require less time.
- Â Allow time to cool, then make sure entire surface area is applied to fabric. If all pieces did not adhere, reapply heat for an additional 20-30 seconds. Allow to cool.
- Turn garment inside out and apply iron to back of design area for approximately 30 seconds. Wait 48 hours before washing, and turn garment inside out when doing so.